We were lucky to recently find a Lego collector in Denmark who had been hoarding quite a few brand new service packs of electrical wires since the mid-1980s. They are the longer 30-inch leads compatible with both 4.5-volt and 12-volt motors and light bricks. We convinced him to part with the lot for the right price so we could offer the individual cables to Lego builders who need just one to connect to a motor or dozens to light up an entire Lego town. The wire can be bundled and secured with a rubber band if a shorter length is needed for your project.

Lego made various styles of electrical wire connectors. This is the modern (circa 1985) version with two metal prongs on each end and a center plastic nub. Make sure your motor or light brick has a center "diffusor" hole that will accept this type of connector without modification. Lego part #x466.

You can daisy-chain an unlimited number of these wires together for lighting up an entire Lego town with a single battery box by plugging in the next lead's prongs to the edge sockets of the previous plug.

• Compatible with 4.5-volt & 12-volt
• Necessity for motors & light bricks
• 30-inch length (about 75cm or 96 studs)
• 2 prongs on each connector
• Center nub secures plug in socket
• Multiple wires can be daisy-chained
• Rare unused mint condition

Condition: Brand new electrical wire removed from the original service pack and gently straightened to check for kinks. Attached to a 4.5-volt battery box and light brick for several seconds to ensure power was properly transmitted. Since this wire has never been used for play, the prongs are straight and rigid and will not slip out when attached to a motor or light brick that has factory-new or gently used sockets. Loosely coiled and individually wrapped to prevent kinks or tangling.

More information at www.Bricklink.com and www.Peeron.com

Light brick sold separately

Light brick sold separately

Lights and extra wires sold separately

Weight: 0 pounds 1 ounce
Size: 4" L x 3" W x 0.5" H